Sizing a Grease Trap
If you operate a restaurant or other commercial facility, you may have wondered "what size grease trap do I need?" Commercial grease traps are sized according to the rate of incoming flow, in gallons per minute (GPM). Associated with this incoming flow rate is the trap's capacity. This rated capacity, in pounds, is listed at twice the flow rate. For example, a 10 GPM trap has a rated capacity of 20 pounds. All calculations, formulas, and charts used to determine grease trap sizing and capacities are widely accepted by most plumbers and regulatory agencies. Always check with your local authority and plumber for specific regulations and recommendations on grease trap sizing. For Pot Washing Sinks, the Plumbing and Drainage Institute (PDI) recommends that you round up to the next available size when determining the correct grease trap for your application.
Determine the flow rate of your sink:
1. Calculate the capacity of the sink in cubic inches (measurements of one compartment), and multiply that total by the number of compartments:
Length
inches
Width
inches
Depth
inches
Number of Compartments
Total Cubic Inches of Sink for all compartments
2. Convert the capacity from Total Cubic Inches to Gallons Per Minute (GPM) by dividing 231:
Total Cubic Inches of Sink ÷ 231 = GPM
GPM
3. Adjust for displacement (displacement takes into consideration the actual usable capacity of your sink):
GPM x 0.75
The resulting GPM is the required flow rate to drain the sink in one minute.
Flow Rate
2 minute drain time (recommended)
1 minute drain time (only if required by ordinance)
TOTAL Actual Drainage Load (GPM)
*The listed GPM is the required flow rate for your application. You should choose a trap with this GPM or the next higher GPM.
If Draining Multiple Sinks Into One Grease Trap
1.) Determine the flow rate for each sink to be serviced by the grease trap using the same calculations as a single sink. 2) Add together 100% of the largest flow rate, 50% of the second largest, and 25% of all others. 3.) The result is the recommended flow rate (in GPM) of the grease trap.
Dishwashing Machines
Normally, authorities require that dishwashers have individual grease traps. Since regulations may vary, we suggest you consult your local authorities.
Get a copy of these results for your records
Provide your name and email, and we will email you the results of your calculations
Name
First Name
Last Name
Company
Email
example@example.com
Get a copy of your results
Disclaimer
All calculations, formulas, and charts used to determine grease trap sizing and capacities are widely accepted by most plumbers and regulatory agencies. Always check with your local authority and plumber for specific regulations and recommendations on grease trap sizing. This application is not a substitute for your professional judgment or independent testing and calculation. We are not liable for any direct or indirect damages related to this application. By completing this form, you agree that we may follow up with you about grease traps or other related products. You may opt out at any time.
Select your Grease Trap!
CLICK HERE
to view all our grease traps.
4 GPM Grease Trap
7 GPM Grease Trap
Should be Empty: