• Assembly Single Door QC

  • Solidcor Door Number*

  • Details

  • Solidcor and IFCC labels on top of door leaf:*
  • Doorleaf QA Label:*
  • Doorframe QA Label:*

  • Specification

  • Is the doorset size correct?*
  • Is the doorset handing & opening correct?*
  • Is the doorset opening direction correct?*
  • Is the door style & skin colour correct? Check door specification requirement against information on the product information area. if unsure.*
  • Is the skin colour correct? Check skin colour against door detail sheet on the door.*
  • Where required, has Smartdor / Auro Sensors and Magnets been fitted in the correct locations?*
  • Top Sensor QR Code*
  • Top Sensor Photo*
  • Top Magnet Photo*
  • Side Sensor QR Code*
  • Side Sensor Photo*
  • Side Magnet Photo*
  • Is the glazing style and type correct?*

  • Visual Inspection

  • Is the door in good condition and free from damage and chipping around the edge? Check edgeband tape for adhesion*
  • External Face of Door, with compression cards. *
  • Production Sheet and Wallet*
  • Internal Face of Door*
  • Is the timber frame in good condition and free from indentations and splintering?*
  • Is the UPVC frame weld free from cracks?*

  • Assembly Checks

  • Photo of gap gauge to head of door. *
  • Photo of gap gauge to hinge side of door.*
  • Photo of gap gauge lock side of door.*
  • Photo of Dropseal Operated*
  • Are all the screws present and square in the hinges?*
  • Photo of top hinge(s):*
  • Photo of bottom hinge(s):*
  • Are all the screws present and square in the lock?*
  • Photo of lock forend:*
  • Are all the screws present and square in the lock keep(s)?*
  • Photo of lock keep(s):*
  • Are the correct intumescent seals included and attached to the doorset?*
  • Has the doorset got glazing in it?*
  • If the doorset has got glazing within it, is this free from damage and cracks?*
  • Photo of glazing:*

  • Door Measurements

    Photograph the gap gauge clearly at each required location, showing the gap between the door leaf and frame. The required gap is 2–4 mm. Head: Take three photos across the width — left, middle and right. Lock side: Take one photo near the head, one above the lock/latch and one towards the bottom of the door. Hinge side: Take one photo near the head, one between the top and middle hinges, one between the middle and bottom hinges, and one between the bottom hinge and the foot of the frame. All ten gap photos are required.
  • Are the gaps between 2 - 4mm between frame and door leaf?*
  • Lock side – top*
  • Lock side – above lock*
  • Lock side – bottom*
  • Hinge side – top*
  • Hinge side – top/middle*
  • Hinge side – middle/bottom*
  • Hinge side – below bottom hinge*
  • Head – left*
  • Head – middle*
  • Head – right*
  • Threshold gap show gap gauge. R30/R60 2.5mm - 4mm, T30 7mm - 9mm, T60 4mm - 6mm.*

  • Final Check

    By marking this door complete you are agreeing that this doorset is compliant and within tolerances. You also acknowledge that the doorset is in good condition and aesthetically finished well.
  • I am happy this doorset complies with our QC checks and is fit to be delivered to our customer.*
  • Date*
     / /
    2 digit day, 2 digit month, 4 digit year
  • Should be Empty: