Here's What You Need
In order to flash/tune your car with APR software, there are two requirements you must have prior to completing this form or setting up an appointment with a USP Tech. You must also download and install the TeamViewer software in order to allow a USP tech to remote into your laptop or device during your appointment. Please also note your car cannot have any previous flashes/tunes/software other than APR. If you have any other software, it must be flashed back to stock prior to your appointment. Failure to do so may lead to your ECU bricking. USP Motorsports and APR are not liable for ECU bricking, however, USP will assist you with further instructions should this occur.
Requirements to Flash/Tune
1. ODIN | APR ECU/TCU Software Purchase (Vehicle Specific) - Shop Now
2. APR Software Flashing Cheetah Cable - Shop Now
Highly Recommended Hardware Kit:
1. APR at Home ECU/TCU Flashing Kit - Shop Now
Recommended Individual Hardware:
1. Ross-Tech™ VCDS Diagnostics Cable - Shop Now
2. Battery Jump Starter - Shop Now
Team Viewer Remote Session
Your vehicle will be flashed/tuned using a remote session to your Windows Laptop or device. A teamviewer download is required prior to scheduling a session with a tech. Please use the link below to download and install TeamViewer on the laptop you will be using to connect to your car. At the time of your appointment, a USP tech will ask you for your Teamviewer ID and temporary password, please have that ready.
Teamviewer Download Link - Download
Ross-Tech VCDS Software Download
With the required Ross-Tech VCDS cable, you must also install the VCDS software. Please ensure your cable has been tested with the VCDS software prior to your appointment. Instructions for installing and testing can be found below, along with a download link from the Ross-Tech Site.
Ross-Tech VCDS Software Download Link - Download
Ross-Tech Installation Instructions - Open VCDS Instructions