Rough-In Installation Virtual Inspection Checklist

Public Protection Cabinet Department of
Housing Buildings and Construction
Division of Plumbing 500 Mero St, 1st FI
Frankfort, KY 40601

Rough-In Installation Virtual Inspection Checklist

Email of the Journeyman Submitting:

example@example.com

Journeyman plumbers signature

Journeyman License Number (after the "J"):

Date of test

Date

Permit number

Address of installation

Type of construction

Type of Material Used:

Building Drain Size:

Proper installation methods used followingmanufacturer recommendations:

Pitch on pipe no less than 1/8” per foot:

Proper fittings and materials installed: (Ex: Directional flow, etc.):

Proper hangers and spacing of the hangers for Waste/Vent:

Proper flashings installed:

Confirmed water closets with flush rate less than 1.6 gallons are not on a cross/double tee:

Type of test used on Waste and Vent:

If air test was used on Waste & Vent, what pressure (in psi):

Type of Materials Used for Water Supply?

Other

Proper Installation methods used following manufacturer recommendations:

Main supply control valve full port and accessible within occupied space:

Is a drip or drain valve provided to drain system completely:

Are all water pipes protected from freezing:

Proper hangers and spacing of the hangers for water lines:

When using PEX, were proper distances kept for recessed lighting, metallic flue piping, petroleum based products, etc.

Trap primers installed properly to floor drains and where only T&P valve discharge into open receptacles.:

In residential use, are hose bibbs installed in front and rear of home with a shutoff valve:

Pressure balance valve utilized on all shower and tub/showerCombinations:

Type of Testing For Water Lines:

If Air used to test water, what was the pressure (in PSI):

Office Contact:

example@example.com

File Upload