Tower Crane 2 Weekly

Tower Crane Inspection Checklist - Weekly

PCL HSE Operating Procedures - Tower Cranes - Procedure HSEOP-02-05
Project:
For week beginning:

MonthDayYear
Date
Equipment number:
WEEKLY Service and Maintenance Inspection
Check structural bolts and pins (bolts torqued to specifications one week after erection: replace any nuts or bolts which have become loose that were tight initially).

MonthDayYear
Date
Check trolley rollers, tracks, slewing rings, and rollers.

MonthDayYear
Date
Check all moving parts: Gear, shaft, belt drives, trolley slewing, rollers, tracks, slewing ring, guy ropes, pendant lines, cable clips, thimbles, and ferrules.

MonthDayYear
Date
Test Dynamometer (Dial Head) with Test Block.

MonthDayYear
Date
Jacking, see tower crane manual for correct procedures: removed and/or covered jacking unit.

MonthDayYear
Date
Check vertical plumb bob.

MonthDayYear
Date
Remarks: Record of Corrective Action
Operators Signature
Superintendents Signature (not required)
A copy of this form will be sent to this email:
example@example.com
NOTE

It is intended that the equipment be checked daily and weekly by the operator. Any defect must be reported under the space left for remarks. The superintendent will in turn notify the project manager and/or PCL Construction Resources Inc., who will see to it that the defect is remedied. This weekly check does not relieve the operator of the responsibility to immediately report to the superintendent any fault. This weekly report is to be retained in the Daily Checklist Book or will be available digitally within the project Egnyte folder.
Should be Empty:

Tower Crane Inspection Checklist - Weekly

WEEKLY Service and Maintenance Inspection