Note: To avoid customer confusion, we are separating the head and foot sides from the left and right sides. Head and foot barriers are now referred to as "Rails" and are selected separately from the sides. "Sides" now only refers to the left and/or right barriers, if selected.

1. Gunnell will select factory settings if no setting is made.

2. Inside Width (IDW: B, S, or L): The measurement between side pads, side ABS, or width of top platform, whichever is smallest.

3. Inside Length (IDL: B, S, or L): The measurement between side pads, side ABS, or width of top platform, whichever is smallest.

4. Outside Width (ODW: B, S, or L): Inside Width, IDW, plus the following measurement whenever

   applicable:

   (i) 2” for fixed sides;

   (II) 3” for hinged flip down sides;

   (III) 4” for removable sides when sides not removed;

   (IV) 5” for angle adjustable locking sides; and

   (V) padding thickness

5. Outside Width is the Inside Width for removable sides when sides removed.

6. Platform to Floor Height: measurement from the ground to the top of the platform below the ABS.

7. Maximum 8 sides/rails, left side 1, left side 2, left side 3, right side 4, right side 5, right side 6, head rail, and/or foot.

8. Side/Rail Height: measurement from the top of sides to the top of steel platform, ABS, or base pads, whichever is the smallest.

9. Factory setting of 8” Side/Rail Height is measured from top of steel platform to the top of sides/rails.

10. Seat and Leg can be combined as one platform without hinge point in between. Cross out leg platform, initial next to it, write full length in seat position, and cross out knee angle and initial next to it.

11. Static angle adjustments require tools

12. Dynamic angle adjustments are released by a cable assembly and require no tools.

Email: support@gunnell-inc.com • Tel: 800-551-0055 • Fax: 800-794-5483

Specifications and prices are subject to change without notice.