Gunnell will select factory settings if no setting is made
Inside Width (IDW): The measurement between side pads, side ABS, or width of top platform, whichever is smallest
Inside Length (IDL): The measurement between side pads,
side ABS, or width of top platform, whichever is smallest
Outside Width (ODW): Inside Width, IDW, plus the following
measurement whenever applicable:
(i) 2” for fixed sides;
(II) 3” for hinged flip down sides;
(III) 4” for removable sides when sides not removed;
(IV) 4.5” for angle adjustable locking sides; and
(V) padding thickness
Outside Width is the Inside Width for removable sides when sides removed
Platform to Floor Height: measurement from the ground to the top of the platform below the ABS. Add seat base padding for desired final Platform to Floor Height where applicable.
Maximum 4 sides: head, foot, left side and right side.
Side Height: measurement from the top of sides to the top of steel platform, ABS, or base pads, whichever is the smallest
Factory setting of 8” Side Height is measured from top of steel platform to the top of sides
Inside Length IDL: (in inches)* Inside Width IDW: (in inches)* Outside Length ODL: (in inches)* Outside Width ODW: (in inches)* Height of Side (see notes 7,8,9 above) SH: (in inches)* Platform to Floor Height (see note 6 above) H: (in inches)* Maximum allowable cart width (maximum allowable cart width for going through doors) ODW: (in inches)*
Base pad thickness (in inches)* Side pad thickness (in inches)*
Email: support@gunnell-inc.com • Tel: 800-551-0055 • Fax: 800-794-5483
Specifications and prices are subject to change without notice.