Emdee-Custom Panels Quote Request Form

Custom Panels Quote Request Form

Please fill out this form to request a custom drapery quote. Please email jenny@goemdee.com if you haven't received your quote within 48 hours.
Date

MonthDayYear
Date
Company Name*
Contact Name*

First NameLast Name
Address*

Street Address

Street Address Line 2

CityState / Province

Postal / Zip Code
Phone Number*
Please enter a valid phone number.
Email*
example@example.com
Fabric Name: *
Fabric Color:*
Client Name or Sidemark:*
Please specify a client name or side mark for this quote.
Are Your Panels Stationary or Functional?*

StationaryFunctional
Qty of Stationary Panels:
What is the Width of your stationary panel?
Quantity of Rods
What is the width of your rod? (In Inches)
What is the finished width or total length of the rod that your panels need to cover?
What is the Draw of your panels?
What is the Finished Length of your panel? (in inches)*
This is usually measured from the rod to where you want the panels to hit the floor. Be sure to include any deductions for your hardware. If you have a drapery ring or carrier, you need to measure from there to the floor.
Lining*
We use a white lining on all our panels. An ivory lining can be special ordered for an additional charge.
Top Treatment*
Specify your Pleat:*
Pleat Return: *
Our standard return is 3.5 , please specify if you need a bigger return. The return should be the same size that your rod bracket extends from the wall.
Pleat Overlap: *
Our standard overlap is 2". Please specify if you need a bigger overlap. If you are adding a tape trim, the overlap size should be the at least the size of the trim.
Rod Pocket /Back Tab Size: (inches)
Grommet Finish: *
Ripplefold Fullness
Ripplefold is a contemporary top treatment that operates on a traverse rod and is great for functional panels.
Ripplefold Master:
The buttmaster carriers allow the panels to butt up against each other. The overlap masters allow a fabric overlap in the center, which is preferred when doing blackout panels.
Add a Trim to my panel:
Trim Name:
Trim Color:
Trim Location:
Trim Placement
Specify the number of inches the trim should be inset from the edge.
Any special notes or instructions:
Should be Empty: