Fabrication Data Sheet

Fabrication Requirements
Material Test Reports for All Materials
Strength Test Required
Strength Test: Minimum Pressure (PSIG)
(If you don't have an answer input "Standard")
Duration of Strength Test (Hours)
Test duration will be a minimum of 1 hour per 49 CFP 192.507.C
Type of Test Record Required
If you selected "Other"
Customer/Third Party Witness of Strength Test?
Weld Map Required
Non Destructive Testing (NDT)
Percent of welds for NDT (Percent)
(If you don't have an answer input "Standard")
Third Party Inspection of Welds
Surface Preparation Specification
Standard specification is to blast per SSPC-SP-10 1.5-2.5 mills (If you don't have an answer input "Standard")
Paint Specification-Primer Coat
Standard specification is Wilkopon HS 347-67 Red 2-3 mills or similar (If you don't have an answer input "Standard")
Paint Specification-Base Coat
Standard specification is Wilkothane HS 722-72 TGT Gray intermediate coat 4-6 mills or similar (If you don't have an answer input "Standard")
Paint Specification-Top Coat
Standard specification is Wilkopon HS 720-18 Clear top coat 2-2.5 mills or similar (If you don't have an answer input "Standard")
Third Party Inspection of Coating
Customer Inspection Before Shipping
Additional Customer Notes
Additional File Upload
Should be Empty:

Station Design