PDBX 1002-125 *Will only fit 1-1/8"" thick pivot*
NQBX (LH) Stands for Left Hand. If the bifold opens and stacks to the left, you need this part, which is secured on the inside of the track.
NQBX(RH) Stands for Right Hand.If the bifold opens and stacks to the right, you need this part, which is secured on the inside of the track.
MZCK 1010 The pivot guide goes inside of the track, the top pin (1029-1) needs to snap into this piece.
MTBX 1003-1 The standard floor plate is good on all flooring types. Provide your own screws to adhere to flooring.
TXBX 1026. The flat floor plate is used on flat floors, to provide a tighter undercut clearance of 5/8" gap.
NFBX 1022. #8 x 1/2" Tek screws. Used to screw the track stop into the track.
NAEB 1013. The vinyl tube gets placed inside of the top track. It is placed in, to protect the panels from touching when the bifold closet door is in the open position.
URCX 1015. The satin nickel wire pull is to be installed on 1/3 of the width of the panel from the hinge side, on the glide panel.
USBZ 1015-1. Purchase 2 of these screws, to install the satin nickel pull, since there are 2 entry points into the door.
MYBX 1009. The standard screw is used to attach the door stop (1019) to the backside of the door. They are also used to attach the pivot bracket (1002) to the top and bottom of the door panel that is the pivot panel.
NIBX 1029. The top pivot pin is used in 2 places for installation. One is locked into the (NQBX) cam lock assembly inside of the track, the bottom of the pin gets placed inside of the (1002) top pivot bracket. The other pivot pin, is used with the (1010) nylon pivot guide.
NFEX 1024. The wrench that can adjust the closet door up and down through the stud.
MWFX 1040. A boot that slides over the standard floor plate.
The aluminum bifold track is priced in 1 foot increments. Please select total number of ft needed for project, then scroll down and indicate the closet door widths you need to track cut into. We suggest cutting track slightly over the size of your opening, so when delivered you can cut it to perfect size.
RFCU 1050-125. The magnetic catch assembly, gets installed to the track and the backside of the door. Each panel needs a magnetic catch assembly.
RLBX 1050-125. The safety plate is used for all Advantage series thickness doors, to keep the cam lock assembly from sliding at all inside of the track.