Electrical Safety Check – Report 

This electrical safety check is for electrical safety purposes only and is in accordance with the requirements of the Residential Tenancies Regulations 2021 and is prepared in accordance with section 2 of the Australian/New Zealand Standard AS/NZS 3019, Electrical installations Periodic verification to confirm that the installation is not damaged or has not deteriorated so as to impair electrical safety; and to identify installation defects and departures from the requirements that may give rise to danger.

B. EXTENT OF THE INSTALLATION AND LIMITATIONS OF THE INSPECTION AND TESTING

Details of those parts of the installation and limitations of the safety check covered by this certificate Tick those parts of the installation included in the safety check – if not applicable or not part of the installation – mark NI if not included in the safety check – add additional information if required.

Section B Tick included areas, and mark NI (Not Inspected) if not included or applicable. Add comments as needed.

C. SAFETY CHECK – VERIFIED BY VISUAL INSPECTION

As far as practicable, a visual inspection of the following items has been conducted in accordance with the requirements of Sections 3 and 4 of AS/NZS 3019:2007 – Electrical installations - Periodic Verification.

Mark as NI (Not Inspected) where not included in the safety check. Additional observations or relevant comments should be noted where required.

Section C -Tick “Included”, or mark “Not Applicable (NA)” or “Not Inspected (NI)”. Use the comment box if needed.

D.SAFETY CHECK - VERIFIED BY TESTING

As far as practicable TESTING of the following items has been carried out per the requirements of 4 of the Australian/New Zealand Standard AS/NZS 3019:2007 Electrical installations - Periodic Verification: mark NI if not included or not applicable in the safety check – add additional information if required.

Section D.1 – Polarity and Connection Testing (AS/NZS 3019:2007)

Section D.2 – Earth Continuity Testing

E.Smoke Alarms
All smoke alarm are correctly installed and in working condition; and have been tested according to the manufacturer's instructions.

All smoke alarms must be tested according to the manufacturer's instructions at least once every 12 months

I the above named licenced electrician have carried out an electrical safety check of this residential tenancies per the requirements of the Residential Tenancies Regulations 2021 and set out in the Australian/New Zealand Standard AS/NZS 3019, "Electrical installations - Periodic verification, and have recorded my observations and recommendations. any