Make sure you have a stable Wi-Fi or LAN connection available at the Emaldo unit. Prepare a Torx T10 screwdriver (T10 bit).To remove the side panel, unscrew the two T10 screws and lift the panel straight up.
1. Hold the power button until the light indicator turns off, then release.
2. Wait 5 minutes.
3. Turn off the main switch (AC Breaker) OR the 3-phase fuse for the Emaldo installation.
4. Wait another 5 minutes.
1. Turn on the main switch (AC Breaker) to ON.2. Hold the power button until the light indicator turns on, then release.3. Wait 2–5 minutes.
Melody
Please open up and check the Emaldo® App
Please follow this guide to reconfigure the Network configuration of the unit.
Network Guide
Network Troubleshooting
Two Beeps
The unit is ready to be configured. Please follow the commisioning guide and answer the question below.
Commissioning Guide
1. Ensure that the Power LED is ON and that at least 5 minutes have passed since the previous step.2. Hold the smaller grey IoT button for 10–15 seconds or until three beeps are heard, then release.
Beep heard
If you have trouble finding your Device ID you can follow this guide