Start Mock Test
Pass Mark 10/12
Your email
*
Type a question
Under the Health and Safety at Work etc. Act 1974 and COSHH, what is your primary legal responsibility as an employee?
To carry out the initial risk assessment for the chemicals you use
To use the RPE provided to you correctly and attend required training
To source and purchase your own RPE if you find the company's mask uncomfortable
According to HSE guidance HSG53, what is the mandatory requirement for users of "tight-fitting" respirators regarding facial hair?
Stubble is allowed as long as it does not exceed 3mm in length
Facial hair is permitted if you tighten the head straps to pull the mask closer
You must be clean-shaven in the area where the mask seal touches the skin
In the UK "Hierarchy of Control," when should RPE be used by an employer?
As the first line of defense because it is cheaper than installing ventilation
Only as a last resort when other controls (like extraction) cannot fully manage the risk
Only if the employee specifically requests it for extra comfort
When must an employee undergo a mandatory "Face Fit Test"?
Before using a mask for the first time and whenever there is a change in the mask model or your facial features
Once every 10 years as part of a general health check
Only if you feel that the mask is not sitting correctly on your face
What is the legislated requirement for the storage of RPE when it is not in use?
It should be stored in a clean, dry container or locker to prevent contamination
It should be hung by its straps on a peg in the work area for quick access
It should be kept in your personal tool bag or pocket for security
Before each use, what "pre-use" check should you perform on your respirator?
Soak the filters in disinfectant to ensure they are sterile
Check that the mask matches the colour of your high-visibility vest
Check for damage, ensure valves move freely, and verify that the straps are intact
How do you identify a filter that is specifically designed to protect against hazardous particles (dust/fumes) rather than gases?
It will have a "P" rating (e.g. P3) and a white colour-coded stripe or label
It will be significantly heavier than a standard gas filter
All RPE filters protect against particles and gases by default
What is the correct legal procedure if your RPE is damaged or you smell/taste a contaminant while wearing it?
Finish your current task quickly and report it at the end of your shif
Leave the hazardous area immediately and report the fault to your supervisor
Apply duct tape to the leak and continue working until your next scheduled break
Why are filtering respirators (like half-masks) prohibited for use in oxygen-deficient environments (e.g. confined spaces)?
The masks are too bulky to fit through small entry points
They only filter out contaminants and do not provide a fresh supply of oxygen
The filter material reacts dangerously with low levels of oxygen
Which mark must be present on RPE to show it meets the required safety standards for use in the UK?
A "Quality Approved" holographic sticker from the manufacturer
A green "HSE Recommended" stamp
A UKCA or CE mark
HSE guidance (HSG53) recommends a maximum continuous wear time for non-powered RPE. What is the standard recommendation?
It should not be worn for more than 1 hour without taking a break
It can be worn for a full 8-hour shift without being removed
It should be removed every 15 minutes to allow the skin to breathe
Who is responsible for ensuring that you have received proper training on how to fit and use your RPE?
It is the employee's responsibility to find tutorials online
The employer must provide the training and ensure you are competent to use the equipment
The manufacturer of the mask is legally required to send a trainer to your site
RPE Tag
Please Select
Pass RPE
To join our mailing list & agree to our privacy policy opt-in below: https://healthandsafetytraining1st.co.uk/privacy-policy/
*
I agree
Please verify that you are human
*
CalculationCorrection
Submit
Score
Should be Empty: