• OIL BURNER AND HOT WATER SERVICE CONTRACTS

    Details of our Oil Burner and Hot Water Service Contracts are below. Please complete the form below to apply.
    Please Note: To enroll in our oil burner/oil hot water heater contracts, all heating oil for the term of the contract must be purchased from Chester County Fuel.

    PLAN A: ANNUAL TUNE-UP and CLEANING SERVICE
    $289/YEAR

    Includes annual cleanout, nozzle, oil filter, strainer, and tank treatment.

    To include H/W HEATER - $120/YEAR.

    EFFICIENCY TEST:
    Our trained technicians, using state-of-the-art analyzing instruments, will test and adjust your furnace, boiler, or hot water heater to operate at a maximum efficiency. You will receive a written report of the results and, where possible, we will make suggestions to result in even greater savings.

    FURNACE, BOILER, AND HOT WATER HEATER CLEANING:

    Our trained technician will completely brush clean and vacuum your furnace, boiler, or hot water heater, smoke pipe and chimney base, remove any carbon deposits and properly lubricate all motor bearings. Our technician will replace nozzles, oil filters, air filters, and other necessary parts as are necessary for maximum efficiency and savings.

    All safety controls will be checked for proper operation and safety.

    PARTS: If needed, oil burner parts other than nozzle, oil filter, strainer, and tank treatment will be supplied and installed at current rates.

     

    PLAN B: COMPREHENSIVE SERVICE and PARTS COVERAGE**
    $329/YEAR

    Includes annual cleanout and 21 parts coverage.
    To include H/W HEATER - $135/YEAR.

    In addition to the ANNUAL TUNE-UP AND CLEANING SERVICE covered in Plan A, the following PARTS are covered by this contract:

    1. Aquastat (Dual or Triple- $45.00 Allowance)
    2. Aquastat (Single)
    3. Burner Coupling
    4. Burner Fan
    5. Burner Motor
    6. Cad Eye Cell and Lead
    7. Combustion Chamber ($45.00 Allowance)
    8. Electrical Wiring (Inter Control- Wiring Harness Not Covered)
    9. Electrodes
    10. Fan Belt
    11. Fan Motor ($45.00 Allowance)
    12. Fuel Pump (Single Stage)
    13. Heating Primary Control (Micro Processors Not Covered)
    14. Ignition Transformer
    15. Combination Primary/Transformer Control ($50.00 Allowance)
    16. Nozzle
    17. Oil Filter Cartridge
    18. Oil Filter (If Existing)
    19. Thermostat- Heating (Single Acting)
    20. Warm Air Combination Fan Limit Control
    21. Tank Treatment

     

    PLAN C:
    PREMIUM SERVICE and PARTS COVERAGE**  $369/YEAR

    Includes annual cleanout and 34 parts coverage.

    To include H/W HEATER - $150/YEAR.

    In addition to the ANNUAL TUNE-UP AND CLEANING SERVICE covered in Plan A, and the PARTS covered by PLAN B, the following PARTS are covered by this contract:

    1. Aquastat (Dual or Triple- $45.00 AllBlower Pulley
    2. Combustion Chamber ($75.00 Allowance)
    3. Fan Motor (Up to 1¼ HP-Variable Speed Motor Not Covered)
    4. Fan Pulley
    5. Aquastat (Dual or Triple- $75.00 Allowance)
    6. Circulator Coupling
    7. Circulator Motor (Up to 1/12 HP)
    8. Circulator Relay
    9. Combination Primary/Transformer Control ($75.00 Allowance)
    10. Fuel Pump - 2 Stage
    11. Pressuretrol
    12. Relay Switch
    13. Electrode Assembly

    PLEASE NOTE: All allowances apply to the combined cost of parts and labor.

    EMERGENCY SERVICE AVAILABLE 24/7 610-344-7234

    **Labor is covered if the part is covered under contract, if not covered, discounted labor rate of approximately 20%.

    Tank treatment now covered under Plans A, B, and C contracts!

    IT IS THE RESPONSIBILITY OF THE CUSTOMER TO SCHEDULE THE ANNUAL CLEANOUT AND SERVICE WORK/RECOMMENDATIONS.

  • CUSTOMER INFORMATION

  •  -
  •  
  • Should be Empty: