Direct Vent Insert Preview Check List
SERVICE TECH
*
Randy
Kyle
Charlie
Mickey
Other
DateTime
INVOICE NO.
Customer's Last Name
Interior Fireplace Information
Photo of existing fireplace (from approx 6' away - include mantle and surroundings)
Photo of existing fireplace (close up)
Front Width / Opening (measure across top and bottom and use the smallest measurement)
In Inches to the nearest 1/4 inch
Back Width (measure at back wall at bottom of fireplace)
In Inches to the nearest 1/4 inch
Fireplace Opening Height (measure left and right sides and use the smallest measurement)
In Inches to the nearest 1/4 inch;
Damper: Is there a damper and is it operable? Are we able to get 2 - 3" pipes through opening?
Any unique or special notes about the fireplace?
Additional photo of anything that you may think is important regarding the fireplace.
Important Clearance Information
How much space is available left and right of the fireplace opening for the shroud?
Answer in inches
Distance from floor to first combustible above fireplace?
Answer in inches
How far does mantle project into room (Mantel Depth)
Answer in inches to nearest 1/4 inch.
Distance from top of fireplace to bottom of mantle at its furthest projection.
Important Chimney Information
Photo of chimney from outside of house (include much of the house for scale)
Height of the Chimney from interior fireplace to top in feet?
35' of pipe is included. Units can be run with up to 40' of pipe (extra 20' must be ordered separately)
Chimney is less than 18' to ground level or flat roof.
Yes, Standard Ladder Installation
No, Lift Equipment Rental is required. ($1,200 to $2,000 quoted per job)
Is there a cap on the chimney?
If yes, is there 16" of clearance for new termination cap to be placed under existing cap?
If no, cap will have to removed, or a hole cut for the new opening. This will typically re-expose other flue's if any.
Important Gas Line information
Is there an operable gas line already run to the fireplace?
If Yes, you may skip the other questions in this section.
We can tie into an existing gas meter or furnace /hot water heater. Take an image of the proposed tie in?
Describe the path needed to run the gas line from an existing source (or new tank) to fireplace. Include holes drilled, drop ceiling etc.
Important Electric Information
Is there electricity available in within 3' of fireplace?
The customer can allow the supplied electric plug to run out of the front of the fireplace or to have an outlet installed at the back of the fireplace, prior to installation date. Most of our units will work without electricity but the customer will lose the function of the blower and lights. If they intend to use the I.P.I.mode this will quickly drain the battery backup.
Submit
Should be Empty: