Thunder Laser Scanning Offset Adjustment

1
Open Settings in Lightburn (press the gear icon or go to EDIT > SETTINGS).
2
Make sure you are in mm/sec mode ( You can change back when done).
3
Are you in mm/sec mode now?* This field is required.
Please Select
Please Select
NO
YES
4
Click the GearScrewdriver icon or go to Edit>Device Settings in Lightburn
5
The Device Settings window should be displayed
6
Is the device settings window displayed?* This field is required.
Please Select
Please Select
NO
YES
7
Go ahead and enable scanning offsets by making sure the toggle is green
8
Is 'Enable Scanning Offset Adjustment' toggled green?* This field is required.
Please Select
Please Select
NO
YES
9
Click the add button
10
Enter the values for each line. Repeat for all lines on the Gold Card
11
Did you click add and enter a line for every speed/value on the card?* This field is required.
Please Select
Please Select
NO
YES
12
Lets compare the gold card to what is entered and check the units (this card is for reference, your numbers will be different)
13
Check these 5 other things, then click OK twice to close the windows and save your offsets
14
Do all the values and settings look to be correct?* This field is required.
Please Select
Please Select
NO
YES
Should be Empty: